Patrick
08-03-1999, 10:49 PM
http://www.thunting.com/geotech/forum/sonar/images/Towplate1x1.jpg
../images/Towplate1x1.jpg
The photo above is the towplate. It is made of 1/4" aluminum and measures 4" x 6". It has 3/16" holes.
I plan on smoothing out the edges a little more and might make a few more since I have the material.
This was the first time I use a drill press in a long, long time ... can you tell?
Patrick
../images/Towplate1x1.jpg
The photo above is the towplate. It is made of 1/4" aluminum and measures 4" x 6". It has 3/16" holes.
I plan on smoothing out the edges a little more and might make a few more since I have the material.
This was the first time I use a drill press in a long, long time ... can you tell?
Patrick