Garrett AT Pro mounted on new Mars MD shaft

I recently purchased a Mars Shaft for my Sorex Pro detector. For those of you who are not familiar with the Mars shaft, it is a pretty well done copy of the Deus style shaft the folds into a small compact package. many like this style when traveling as it can be stored in a carry on bag.
 I liked the shaft so much I decided that I was going buy another along with a AT Pro and do the conversion.
 I purchased a brand new AT Pro from Jeff at Quality Detectors and got it fast. I ordered the Mars shaft from Serious Detecting eBay store For $120.

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

 Now a lot of guys probably wont like the fact that I took a brand new unit right out of the box and hacked it up BUT the final product is worth it in my book.
 I needed to cut the 2 mounting post on the underside of the AT Pro, (you know, those post that snap off and leave your control box hanging by the cord) You will need to follow the measurements given when making these cuts. I opted to cut mine just a tad shorter to get the mount closer to the control box. I had to also trim the small support webs along the side of the mounting post.
 Now this is the important part, MEASRE THE SCREWS YOU USE TO ASSURE THEY ARE NOT TOO LONG AND PUNCTURE INTO THE CONTROL BOX HOUSING!

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

 Now that the mount is attached to the AT Pro control box it is only a matter of sliding it onto the shaft assembly. It has a "Dovetail style rail that it mounts on.

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

 Now I got thinking about the original shaft assembly, it would be nice to be able to unsnap my control box from the Mars shaft with one coil and transfer it to the original shaft set up with another coil, so I got to work.
 I fashioned a tapered "Wedge" like was on the Mars shaft out of a piece of 1/8inch  aluminum I had using a jig saw, file and a drill press. I fashioned the male dovetail with a file to match the female receptacle. I then drilled the upper shaft to mount the wedge. I had to do some measuring so that the control box final mounted would be in the original position and all controls could be easily reached with the users thumb.
 I must say it turned out nicely and is a good solid mount. I can now switch the complete control box over from one coil/shaft combo to another in under one minute and that includes attaching the coil cable!

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

 Test fitting the mount the attaches to control box

You are not allowed to view links.
Please Register or Login

Front view mounted

You are not allowed to view links.
Please Register or Login

You are not allowed to view links.
Please Register or Login

 I really like the final results. The Mars shaft is well made and even a bit sturdier than tits Deus counterpart. It also comes with a ton of different washers as well as the rubber cushions that tension the rod locks. (Take note Deus!)

Linkback:

You are not allowed to view links.
Please Register or Login

http://www.thunting.com/smf/index.php/topic,64894.msg316924.html#msg316924

i say, good info,
and smart way of advertising

Linkback:

You are not allowed to view links.
Please Register or Login

http://www.thunting.com/smf/index.php/topic,64894.msg316934.html#msg316934